How to Clean Battery Terminals
Battery terminals are small metal plates that connect the battery to the device. They’re usually found on the back of most electronic devices and automobiles.
When you charge your phone, laptop, tablet, or any other electronic device, the battery connects to the terminal. The terminal then sends electricity to the device. The same also follows for cars, trucks and mototcycles and these terminals need some TLC once in awhile for them to perform at 100%
Cleaning battery terminals is necessary for keeping your car running smoothly.
Battery Corrosion
Batteries corrode over time. You should check them regularly to make sure they’re working properly.Battery corrosion is usually caused by rust or other corrosive substances entering the battery. Cleaning battery corrosion is very important because it can cause serious damage to the battery if left untreated. Following these six easy steps will help prevent corrosion and extend the life of your battery. Car batteries need to be cleaned regularly.
- Disconnect Your Battery Cables
- Check the Battery Cables and Terminal for Damage
- Brush off the Corrosion from the Battery and Battery Terminals
- Rinse and Dry
- Take Some Corrosion-Preventative Steps
- Reconnect Your Battery to Your Vehicle
Homemade Cleaning Solution
Baking soda is used to neutralize acids. You should use baking soda instead of vinegar or lemon juice because it is less harmful than those two solutions. Apply baking soda to corroded terminals before touching them. When the baking soda bubbles up, this means the acid has been neutralized. Wipe it off with a clean rag.
A regular toothbrush also works best when cleaning batteries. Rubber gloves should be worn while using this method. Baking soda is not corrosive, but it does help remove some of the rust. Rubbing the solution doesn’t dissolve all of the corrosion. Steel brushes are necessary to clean batteries properly.
Corrosion Protection
Petroleum jelly is used to protect batteries from corrosion. Gloved hands should be used when applying petroleum jelly. Rubber caps should be put on the battery terminals before tightening them with a wrench.
Car Battery Corrosion is common cause of Vehicle Malfunction.
Battery corrosion can cause a variety of problems. Some of them include:
1. Poor Performance – Battery corrosion can cause poor performance.Keep your car battery clean. Corrosion can cause problems if left untreated. Cleaning your battery regularly helps prevent future issues.
2. Increased Cost of Maintenance – If you don’t keep your battery clean, you may have to spend more money on maintenance. This could affect your budget.
3. Potential Danger – Rust can form in your battery. This can lead to an explosion. It’s recommended that you avoid leaving your battery unattended.
4. Safety Issues – Corrosion can cause safety hazards. For example, if your battery overheats, it can catch fire.
5. Electrical Short Circuit – If you leave your battery exposed to moisture, it can short circuit. This can result in a dangerous situation.
6. Health Hazards – Corrosion can release toxins into the air. These toxins can harm your health.
7. Inconvenience – Corrosion can make it difficult to work on your vehicle.
8. Disruption of Power – Corrosion can interfere with the flow of electricity. This can disrupt power and cause potential problems.
9. Unnecessary Expense – Corrosion can cost you money. The longer you wait to repair your battery, the higher the cost.
Conclusion
Cleaning your car battery terminals is as essential as keeping your engine running. You should check the terminals every time you start your car. Look for corrosion, dirt, or any other damage that might cause your battery to fail. Your battery could be damaged, and you don’t want to risk it. Also, if you see signs of serious battery damage, such as a leak or blooming, forget about cleaning it and immediately replace it. A damaged and leaking battery is very dangerous. Seek Expert advise all the time! #SulitTips
